The problem and solution of wrong box in automatic molding machine

来源：Guangdong Zoomzu Machinery Equipment Co., Ltd 发布日期:2018-07-07 浏览：3221

The problem of wrong box in automatic molding machines is mainly caused by the following factors:

1. The design and installation of the template itself are misaligned; ‌

2. Uneven placement of the template during molding, and incorrect movement of the sand mold when moving; ‌

3. There are sand blocks stuck on the inner wall of the lower box, which push the sand mold to move incorrectly; ‌

4. Pushing too quickly and shifting up and down; ‌

5. The mold is uneven and the upper box sand tire is tilted. ‌

To address these issues, the following solutions can be taken:

1. Ensure the correct design and installation of the template to avoid misalignment; ‌

2. During the modeling process, pay attention to the placement of the template to ensure its stability; ‌

3. Clean the inner wall of the box to avoid sticking sand blocks; ‌

4. Control the pushing speed to avoid misalignment caused by excessive speed; ‌

5. Adjust the molding process to ensure that the upper box sand tire does not tilt. ‌

Through these measures, the problem of wrong boxes in automatic molding machines can be effectively reduced, and production efficiency and product quality can be improved.